EasyManuals Logo

Yamaha 6c User Manual

Yamaha 6c
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
3-13
GB
10) Return the throttle control grip slowly
to the fully closed position so that the
engine does not stall.
cC
8 Never push the starter-switch while the
engine is running.
8 Do not keep the starter motor turning
for more than 5 seconds. If the starter-
motor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it
impossible to start the engine. If the
engine will not start after 5 seconds of
cranking, release your hand from the
starter-switch, and crank the engine
again after an interval of 10 seconds.
309012
EMG00010-X
WARMING UP ENGINE
1) Before beginning operation, allow the
engine to warm up at idling speed for
3 minutes. (Failure to do this will
shorten engine life.)
2) Check for a steady flow of water from
the cooling-water pilot hole.
cC
A continuous flow of water from the pilot
hole shows that the water pump is
pumping water through the cooling pas-
sages. If water is not flowing out of the
pilot hole at all times while the engine is
running, do not continue to run the
engine. Overheating and serious damage
could occur. Stop the engine and check
to see if the water inlet on the lower cas-
ing is blocked. If the problem cannot be
found and corrected, consult your Yama-
ha dealer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha 6c and is the answer not in the manual?

Yamaha 6c Specifications

General IconGeneral
BrandYamaha
Model6c
CategoryOutboard Motor
LanguageEnglish

Related product manuals