Adjusting the Display Brightness
CP5/CP50 Owner’s Manual
17
Setting Up
Adjusting the Display Brightness
1 Press the [UTILITY] button on the right-hand side of the control panel to call up the Utility screen.
2 Press the [A] button on the right-hand side of the control panel to jump to Page 11 (A) within this screen.
3 Adjust the display brightness by turning Knob 1 and changing the value of the Bright (brightness) parameter.
The darkest setting is “1”, and the brightest setting is “4”.
NOTE As an alternative to the above-described method, the display brightness can also be adjusted directly using the [UTILITY] button and the
[L PAGE] and [PAGE R] buttons. Specifically, the brightness can be reduced by holding down the [UTILITY] button and pressing the [L PAGE]
button, and it can be increased by holding down the [UTILITY] button and pressing the [PAGE R] button.
Adjusting the Volume
The stage piano’s output volume is adjusted using the [MASTER VOLUME] dial located at the left of the control panel.
Whenever making adjustments using this dial, it is wise to listen to the actual volume as you play.
NOTE The [MASTER VOLUME] dial also controls the volume of the headphones.
NOTICE
Whenever you make adjustments using the [MASTER VOLUME] dial, you simultaneously set the level of sound being output via the
headphones jack, the unbalanced [L/MONO] and [R] output jacks, and in the case of the CP5, the balanced [L] and [R] output
connectors. It is very important to remember this fact if monitoring via headphones when keyboard amplifiers or powered speakers are
also connected as they may become extremely loud.
BrightAutoLoad
3off
213
Knob 1 Knob 2 Knob 3
CP5
To Next Page
Loading...
Need help?
General
