Yamaha F200 User Manual

Instruments and indicators
40
Press the confirm button to change to normal
display, and the engine alert icon will start to
blink.
NOTICE
ECM00093
Do not continue to operate the engine if an
alert device has activated. Consult your
Yamaha dealer if the problem cannot be
located and corrected.
The engine alert icon will appear according to
the kind of abnormalities. The symbols and
their explanations are described as below.
 Overheat alert “ ”
If the engine temperature rises too high
while cruising, this alert will be activated.
Stop the engine immediately. Check the
cooling water inlet for clogging, and clear it
if it is blocked.
NOTICE
ECM01594
 Do not continue to run the engine if the
overheat-alert indicator blinks. Serious
engine damage will occur.
 Do not continue to operate the engine if
an alert device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
 Low oil pressure alert “ ”
If the engine oil pressure drops too low, this
alert will be activated. Stop the engine im-
mediately. Check the engine oil level and
replenish oil if necessary. If the alert device
has activated while the appropriate engine
oil level is maintained, consult your
Yamaha dealer.
NOTICE
ECM01602
Do not continue to run the engine if the
low oil pressure alert device has activated.
Serious engine damage will occur.
 Water separator alert “ ”
If water has accumulated in the water sep-
arator (fuel filter) while cruising, this alert
will be activated. Stop the engine immedi-
ately and see page 103 of this manual to
drain the water from the fuel filter. Consult
a Yamaha dealer.
NOTICE
ECM00911
Gasoline mixed with water could cause
damage to the engine.
 Low battery voltage alert “ ”
If the battery voltage drops, this alert will be
activated. Get back to the port soon if the
low battery voltage alert device has activat-
ed. For charging the battery, consult your
Yamaha dealer.
1. Pop-up window
2. Confirm button
1. Engine alert icon
ZMU08859
1
2
ZMU08860
1
U6DV37E0.book Page 40 Monday, December 10, 2018 4:07 PM
©2020 Yamaha Motor Corporation

Yamaha F200 Specifications

General

Prop Shaft Horsepower	200 hp
Full Throttle RPM Range	5000 - 6000 rpm
Compression Ratio	10.3:1
Gear Ratio	1.86:1
Starting System	Electric
Steering	Remote
Trim & Tilt	Power Trim & Tilt
Displacement	2785cc
Bore x Stroke	96.0mm x 96.2mm
Fuel Induction System	EFI (Electronic Fuel Injection)
Alternator Output	50 Amp
Weight	227 kg (500 lbs)
Shaft Length	L: 20 in, X: 25 in