Operation
61
EMU40412
Outboard motor
Check that the outboard motor is mounted
properly and check the outboard motor
mounting bolts for looseness.
Check the propeller for damage.
Check for engine oil leaks.
EMU36494
Flushing device
Check that the flushing device’s garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling. NOTICE: If the
garden hose connector is not properly
connected, cooling water can leak out and
the engine can overheat during operation.
[ECM01802]
EMU40752
Installing top cowling
1. Check the rubber seal for damage. If the
rubber seal is damaged, have it replaced
by a Yamaha dealer.
2. Check that the rubber seal is seated all
the way around the bottom cowling.
3. Check that all of the cowling lock levers
are pulled outward.
4. Align the 3 protrusions on the top cowl-
ing with the corresponding holders on
the bottom cowling, and then place the
top cowling on the bottom cowling.
1. Oil dipstick
2. Upper mark
3. Lower mark
1. Fitting
2. Garden hose connector
3. Flushing device
1. Rubber seal
2. Bottom cowling
1. Top cowling
2. Protrusion
3. Holder
4. Bottom cowling
U6DV37E0.book Page 61 Monday, December 10, 2018 4:07 PM
©2020 Yamaha Motor Corporation
To Next Page
Loading...
Need help?
General
