3-19
E
2. For the first 5 minutes, run the engine at
trolling speed only. For the 30 minutes of
operation after that, keep the engine
speed below 5,000 r/min. For the 1 hour
of operation after that, keep the engine
speed below 8,000 r/min.
3. Proceed with normal operation.
@
Failure to follow the engine break-in pro-
cedure could result in reduced engine
life or even severe engine damage.
@
EJU21061
Launching the watercraft
Make sure that there are no obstructions
behind you.
Use the remote control transmitter to
select the unlock mode. (See page 2-20 for
Yamaha Security System and low-RPM
mode selection procedures.)
After the watercraft is in the water, start
the engine. Shift into reverse and move the
watercraft back slowly. If there are waves,
someone should make sure that the water-
craft is not pushed into the trailer before
backing away.
E_F1X-10.book Page 19 Friday, August 5, 2005 10:34 AM
To Next Page
Loading...
Need help?
General