3-27
E
EJU10750
Boarding and starting in deep
water
WARNING
@
●
Operator and passenger should prac-
tice getting on board in shallow water
before riding in deep water. Boarding
in deep water requires more skill.
●
The fatigue and exposure that could
result after unsuccessful attempts to
get back on the watercraft may
increase the risk of injuries and drown-
ing.
@
EJU22290
Boarding alone
1. Swim to the rear of the watercraft and
place both hands on the boarding plat-
form, pull yourself up, and then grasp the
handgrip with one hand.
2. Pull yourself up to a kneeling position on
the platform, and then move to the seat
and sit astride.
3. Attach the engine shut-off cord to your
left wrist, and then install the clip to the
engine shut-off switch.
4. Grip the handlebars firmly with both
hands, place both feet on the floor of the
footwell, start the engine, and then look
in all directions before starting off.
N
TE:
@
If your watercraft is equipped with the
reboarding step (for FX Cruiser High Output),
you can lower the step to make reboarding
easier. The step returns automatically to the
up position after you have boarded.
@
WARNING
@
Before starting off, make sure that there
are no boats, obstructions, or swimmers
around you.
@
E_F1X-10.book Page 27 Friday, August 5, 2005 10:34 AM
To Next Page
Loading...
Need help?
General