Selecting and Playing Songs
51
3
Start the selected song.
Press the [START/STOP] button. As the song plays back, the measure num-
ber and chords are shown in the display.
4
Stop the song.
Press the [START/STOP] button. If playback was started by pressing the
[START/STOP] button, the selected song stops automatically.
A-B Repeat
The convenient A-B Repeat function is an ideal aid for practicing and learning. It
allows you to specify a phrase of a song (between point A and point B) and repeat
it — while you play or practice along with it.
1
While playing a song, set point A (the start point).
During playback, press the [A-B REPEAT] button once, at the beginning
point to be repeated.
2
Set point B (the end point).
As the song continues playing, press the [A-B REPEAT] button once again,
at the ending point to be repeated. The selected phrase repeats indefinitely
until stopped.
• You can play along with the song
using the currently selected
voice, or even select a different
voice for playing along. Simply
call up the Voice mode while the
song is playing back and select
the desired voice. (See page 23.)
REPEAT
A-
• The A and B points can only be
specified at the beginning of a
measure (beat 1), and not at any
point in the middle of a measure.
• If you’re repeat practicing a par-
ticularly difficult section, try slow-
ing down the Tempo to an
appropriate speed to make it eas
ier to play and master the part.
You may also want to slow down
the Tempo while setting the A
and B points; this makes it easier
to accurately set the points.
• You can also set the A-B Repeat
function when the song is
stopped. Simply use the
[ REW] and [ FF] buttons to
select the desired measures,
pressing the [A-B REPEAT] but-
ton for each point, then start play
back.
• To set the A point to the begin-
ning of a song, press the [A-B
REPEAT] button before starting
playback.
REPEAT
A-b
To Next Page
Loading...
Need help?
General
