PLAYBACK
32 En
Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the
sound output level of your CD player before you play back a CD encoded in DTS.
1 Turn on the video monitor connected to this
unit.
2 Press SPEAKERS A or B on the front panel
(or set the component selector switch to
AMP and then press SPEAKERS on the
remote control repeatedly) to turn on the set
of front speakers you want to use.
Each time you press SPEAKERS A or B, the
respective set of front speakers are turned on or off.
3 Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the desired
input source.
The name of the currently selected input source
appears in the front panel display and in the OSD for
a few seconds.
• To enjoy multi-channel sources in surround, connect the
source component via digital connection and set the input
mode to “AUTO” or “DTS” (see page 35).
• See page 42 for details about surround sound.
4 Start playback on the selected source
component or select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 46 for details about FM/AM tuning
instructions.
• See page 57 for details about DAB tuning
instructions.
PLAYBACK
CAUTION
ZONE 2
ON/OFF
ZONE
CONTROL
EFFECT
PROGRAM
INPUT MODETONE CONTROLSTRAIGHT
SPEAKERSPHONES
MAIN ZONE
MASTER
SILENT CINEMA
BA
MULTI CH
INPUT
VOLUM E
INPUT
ON OFF
ON/OFF
VIDEO L AUDIO R
USBVIDEO AUX
DISPLAY
NEXT
DABSEARCH MODE
MEMORY
MAN'L/AUTO FM
FM/AM
PRESET/TUNING
EDIT
A/B/C/D/E
l PRESET/TUNING h
TUNING MODE
AUTO/MAN'L
LEVEL
66,7 32 5
To Next Page
Loading...
Need help?
General
