Yamaha TDM900 User Manual

6-39
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU01617
Front wheel
Wheel (front)
To remove the front wheel
Removing
EW000122
w
8 It is advisable to have a
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Loosen the front wheel axle
pinch bolt, then the brake caliper
bolts.
1. Wheel axle
2. Front wheel axle pinch bolt
ECA00046
cC
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
2. Loosen the wheel axle with a
19-mm hexagon wrench.
3. Lift the front wheel off the ground
according to the procedure on
page 6-38.
4. Remove the brake hose holders
by removing the bolts.
5. Remove the brake calipers by
removing the bolts.
6. Pull the wheel axle out, and then
remove the wheel.
1
3
2
1. Brake hose holder
2. Bolt (×2)
3. Brake caliper
5PS-28199-E1 8/29/02 9:17 AM Page 84

Yamaha TDM900 Specifications

General

Displacement	897 cc
Bore x Stroke	92.0 mm x 67.5 mm
Compression Ratio	10.4:1
Fuel System	Fuel Injection
Ignition	TCI
Transmission	6-speed
Final Drive	Chain
Front Suspension	Telescopic forks
Rear Suspension	Swingarm (monoshock)
Front Tire	120/70 ZR18
Rear Tire	160/60 ZR17
Seat Height	825 mm
Fuel Capacity	20 liters
Wet Weight	223 kg
Length	2, 180 mm
Height	1, 290 mm
Wheelbase	1, 485 mm
Engine Type	Liquid-cooled, 4-stroke, DOHC, parallel twin
Front Brakes	Dual 298mm discs
Rear Brakes	245mm disc
Max Torque	88.8 Nm (65.5 lb-ft) @ 6, 000 rpm