23 En
Playback
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
2 Press hInput selection keys on the
remote control for the input source whose
remote control code was registered in step 1
for about 3 seconds while pressing down
lSCENE key whose assignment you want
to change. The external component can now
be controlled remotely just by selecting a
scene.
From now on the external component can be remotely
controllable just by selecting a scene.
1 Press rMUTE on the remote control to mute
the audio output.
The MUTE indicator on the front panel display
flashes while audio output is muted.
2 Press rMUTE again to resume audio
output.
You can adjust the balance of the high frequency range
(Treble) and low frequency range (Bass) of sounds output
from the front left and right speakers to obtain desired
tone.
1 Press KTONE CONTROL on the front panel
repeatedly to select “Treble” or “Bass.”
The current setting is displayed on the front panel
display.
2 Adjust the frequency range using
LPROGRAM l / h.
Control range: –10.0 dB to +10.0 dB
The display returns the previous screen soon after you
release the key.
Notes
• The tone control settings are not effective during playback in Pure Direct
mode.
• If you set the balance extremely off, sounds may not match those from
other channels well.
Use Pure Direct mode to enjoy the pure high fidelity
sound of the selected source. When Pure Direct mode is
activated, this unit plays back the selected source with the
least circuitry.
Press NPURE DIRECT (or kPURE DIRECT)
to turn the Pure Direct mode on or off.
NPURE DIRECT lights up when you set Pure Direct
mode on.
The front panel display turns off while the Pure Direct
mode is on. It turns on temporarily when you control this
unit (such as volume control). The front panel display
turns on again once you set the Pure Direct mode to off.
The following features are disabled in Pure Direct mode.
– sound field program, tone control
– display and operation of the option menu and setup
menu
– mulit-zone function
Plug your headphones in the BPHONES jack on
the front panel.
When you select a sound field program while using the
headphones, the mode is automatically set to SILENT
CINEMA mode.
Notes
• When you connect headphones, no signals are output at the speaker
terminals.
• When multi-channel signals are processed, sounds in all channels are
divided to left and right channels. When the input source is set to
“MULTI CH,” only front L/R sound is output from the headphones.
Muting audio output temporarily
(MUTE)
Adjusting high/low frequency sound
(tone control)
Treble
0.0dB
Enjoying pure hi-fi sound
Using your headphones
To Next Page
Loading...
Need help?
General