CHASSIS
3-24
• Do not give a half turn (180) or more for one
tightening.
• Make sure that tightening after a break-in is
done until the initial looseness in nipples disap-
pears.
• Make sure that tightening is done in stages, not
at a time.
EAM30245
CHECKING THE WHEELS
1. Check:
• Wheel
Damage/out-of-round Replace.
EWA13260
Never attempt to make any repairs to the
wheel.
After replacing a tire or a wheel, always balance
the wheel.
EAM30253
CHECKING THE CHASSIS FASTENERS
Make sure that all nuts, bolts, and screws are
properly tightened.
Refer to “CHASSIS TIGHTENING TORQUES”
on page 2-10.
EAM30248
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the in-
ner and outer cables.
EWA13270
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
• Outer cable
Damage Replace.
2. Check:
• Cable operation
Rough movement Lubricate.
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
EAM30483
LUBRICATING THE BRAKE LEVER
1. Lubricate the pivoting points and metal-to-
metal moving parts of the following parts.
• Brake lever
EAM30503
LUBRICATING THE CLUTCH LEVER
1. Lubricate the pivoting points and metal-to-
metal moving parts of the following parts.
• Clutch lever
EAM30250
LUBRICATING THE PEDAL
1. Lubricate the pivoting point and metal-to-met-
al moving parts of the pedal.
EAM30504
CHECKING THE SIDESTAND (for YZ250X)
1. Check:
• Sidestand operation
Check that the sidestand moves smoothly.
Rough movement Repair or replace.
Spoke nipple wrench (6–7)
90890-01521
Spoke nipple wrench (6–7)
YM-01521
Nipple (spoke)
2.5 N·m (0.25 kgf·m, 1.8 lb·ft)
1
G089060
Recommended lubricant
Engine oil or a suitable cable lu-
bricant
Recommended lubricant
Silicone grease
Recommended lubricant
Lithium-soap-based grease
Recommended lubricant
Lithium-soap-based grease
To Next Page
Loading...
Need help?
General
