Yanmar SA424 User Manual

8-14
8. OPERATE THE TRACTOR
SA221/324/424 Operation Manual
4. Insert the screw driver into the hole of the shaft at
the joint of Mid-/Rear Power Take Off (PTO)
select lever under the left fender.
(A) Shaft at the joint of Mid-/Rear Power Take Off
(PTO) select lever
(B) Screw Driver
(C) Left Fender
(D) Rear Left tire
(a) Pulling the screw driver backward to the neutral
gear position.
(b) Pushing the screw driver forward to the in gear
position.
5. Pull the screw driver backward until the shaft can
rotate clockwise (backward).
6. Make sure that the tractor can be moved by hand
and take the screw driver off the hole.
7. After pushing or towing the tractor, return the
shaft to the original position pushing the screw
driver forward until the shaft can rotate
counterclockwise (forward).
■ Push or Tow the Tractor (SA324/424)
1. Push down Power Take Off (PTO) switch to OFF
position.
2. Disengage the parking brake.
3. Move the range shift lever to N (neutral) position.
4. Disengage the 4-wheel drive.
(A) Parking brake lock lever
(B) Power Take Off (PTO) switch
(C) Range shift lever (SA324/424)
(D) 2WD/4WD lever
(E) Brake pedal
NOTE
● This illustration shows from rear side.
● When towing the tractor:
• travel slower than 10 mph (16 km/h)
• always have another person sit on the
tractor to allow independent operation of the
steering and brakes when required
(C)
(D)
(B)
(A)
(a)
(b)
! WARNING
(A)
(C)
(B)
(D)
(E)
SA221_324_424_OperatorsManual.book 14 ページ ２０１８年６月４日 月曜日 午後５時１９分

Yanmar SA424 Specifications

General

Brand	Yanmar
Model	SA424
Category	Tractor
Language	English