10-11
10. 3-POINT HITCH AND DRAWBAR
SA221/324/424 Operation Manual
■ Remove Drawbar
1. Remove the hairpin clip.
2. Remove the pin.
3. Remove the drawbar.
4. Install the pin to the drawbar.
5. Install the hairpin clip.
6. Keep the drawbar to the storage area.
1. Use the appropriate adapter parts to connect the
safety chain to the tractor drawbar support and to
the towed implement.
• Allow enough slack in the safety chain to enable
turning.
2. As necessary, mount additional intermediate
support for the safety chain on the drawbar to
eliminate excessive slack.
• Remove and store the safety chain when not in
use.
(A) Intermediate support
(B) Towed implement attachment point
4. Use the Safety Chain
Avoid injury!
● Always hitch loads being towed to the
drawbar.
● The preceding action prevents the tractor
from tipping over to the rear.
● Never use the safety chain alone to tow a
load.
IMPORTANT
● Always secure the towed implement to the
drawbar.
• the safety chain is only intended to control the
towed implement if the towed implement is
accidentally disconnected from the drawbar
● Always use a chain whose strength is rated
greater than the gross weight of the towed
implement.
● Always replace or repair the safety chain if any of
the chain link/s or connector/s is/are broken,
elongated or damaged.
IMPORTANT
● For safety purposes, ensure that any implements
or trailer towed by the tractor drawbar is
equipped with a safety chain.
• the chain holds the implement when the
implement is accidentally disconnected from the
tractor
● Make sure that the tensile strength of the chain is
greater than the weight of the implement, or that
of the fully loaded trailer.
● A chain shackle whose strength is the same or is
greater than that of the safety chain can be
added to the tractor drawbar bracket where the
safety chain (of the implement or trailer) can be
connected.
● For additional safety, install a chain shackle to
the drawbar bracket.
10_3pointHitch.fm 11 ページ ２０１８年７月６日 金曜日 午前９時４７分
To Next Page
Loading...
Need help?
General
