PRODUCT OVERVIEW
12 SD60 Operation Manual
PAINTING THE BOAT
When painting the boat hull with
anti-fouling paint, observe the following
rules:
• Use high-quality, anti-fouling paint
designed for marine use.
• Avoid using anti-fouling paint that
contains copper material, which could
conduct electrical current.
• Avoid using anti-fouling paint that
contains copper material on the
sail-drive foot in any case.
• If using copper-based or tin-based paints
is necessary, ensure that they comply
with all local and federal laws prohibiting
their use.
• Do not paint drain holes or items as
specified by the boat manufacturer.
• Do not paint any anodes.
CHECK UNDER-WATER
METALLIC PARTS
Check the status of corrosion protection
(boat dry) of the lower part of the hull
before that the boat enters in the water.
Make sure all metallic parts over-hanging
from the hull underneath the seawater line
have to have the same potential.
Contact your local Yanmar dealer for
advice.
This way will assure:
• All metallic parts will have same potential
and will avoid having current/tension
circulation when the boat is in the water.
This create corrosion.
• All metallic parts are properly connected
to the ground of the boat and they are,
therefore, having the same potential.
SD60_OPM.book 12 ページ ２０１７年１２月８日 金曜日 午後３時６分
To Next Page
Loading...
Need help?
General
