| Basic Settings of Teams Room Systems | 62
3. Under the tab of Peripherals, select Yealink UVC30 Camera from the drop-down menu of Yealink
UVC30 Camera.
Note: Tap Preview and pan or tilt the content camera according to the preview to make sure
that the video image of the content camera is contained in the preview.
4. Enable Content enhancements(recommended).
5. Tap Save and exit.
Sharing the Content on the Whiteboard with Remote Participants
In a conference, if you want to share the content on the whiteboard to the remote participants, you can
switch the video image to the content camera and send the content to the remote participants.
Procedure
On the Conference Control page, tap and switch to the content camera.
If there is content sharing now, tap and then select the content camera.
Adjusting the Camera Layout of the MVC940/MVC900/MVC900
Ⅱ
System
After enabling the camera layout feature for Camera-Hub on the Yealink RoomConnect, you can adjust the
camera layout of the MVC940/MVC900/MVC900
Ⅱ
system.
About this task
The following camera layout are supported:
• Fullscreen: the selected camera is displayed in full screen.
• Division: every camera is given equal prominence in equal-sized panes.
• Surround: the assigned camera is given prominence in the largest pane, and other cameras are
displayed in a strip beside the assigned camera.
For more information on how to enable the camera layout feature for Camera-Hub on Yealink
RoomConnect, refer to Yealink RoomConnect User Guide.
To Next Page
Loading...
Need help?
General
