Yealink Telkom T21P E2 User Manual

Using the optional headset:
1. With the headset connected, press to activate the headset mode.
2. Enter the desired number, and then press the Send soft key.
Using the handset:
Pick up the handset.
Answering a call
Using the speakerphone:
Press
Using the headset:
Press
During a call, you can alternate between the headset, hands-free
speakerphone and handset modes by pressing the HEADSET key, the
Speakerphone key or by picking up the handset. Headset mode requires a
headset connected.
Note:
You can reject an incoming call by pressing the Reject soft key.Note:
5. Service Activated
• After a short while the phone will display “Initializing… please wait”.
• Your VoIP service will be activated once the phone has rebooted.
4. Reboot and Complete Setup
• The phone will display “Service Successfully
Activated. Press OK to reboot.”
• Press OK to reboot and complete the setup.
• The provisioning process disables the phone’s administration account. If
you require access to the phone’s management interface, please contact
 support.
• If the activation was unsuccessful, check your network settings and
move back to step 1, Provision  IP Voice Service, and try again.
• If the problem persists, contact device support if any error appears
during the provisioning process.
Note:
Register status icons on the LCD screen:
Registered
Register Failed
Registering
Basic Call Features
To place a call directly:
1. Pick up the handset.
2. Enter the desired number, and then press the Send soft key.
To place a call from the local directory:
1. Press Dir soft key when the phone is on-hook, then select All Contacts.
If multiple numbers for the contact are stored, press or to highlight the
desired number, and then press Send again to dial out.
2. Press or to highlight the desired entry, and then press Send to dial out.
Using the speakerphone:
1. With the handset on-hook, press .
2. Enter the desired number, and then press the Send soft key.
Making a call
Using the handset:
Hang up the handset or press the EndCall soft key.
Ending a Call
Using the speakerphone:
Press or press the EndCall soft key.
Using the headset:
Press the EndCall soft key.
Redial
Press twice when the phone is idle to dial out the last dialled number.
Press to enter the Placed Calls list, press or to select the desired entry,
and then press or the Send soft key.
5 6

Yealink Telkom T21P E2 Specifications

General

Brand	Yealink
Model	Telkom T21P E2
Category	IP Phone
Language	English