YOKOGAWA DY100 User Manual

5-1
IM 01F06A00-01E
5. PARAMETER SETUP
5.1 Parameter Setup
The parameters are set before factory shipment. Set the
required parameter of changing fluid, contact out and
indication of display.
5.2 Multi-Variable Type Parameter
(Only for /MV)
Parameter item F is indicated when /MV is selected.
The parameters are set before factory shipment, but it is
necessary to set the analog output of temperature, span of
temperature output.
IMPORTANT
For the remote type, be sure to set the cable length
(F52) for DYA, remote type converter, because of
effect of the cable length.
5.3 Parameters List
This section describes the parameter of digitalYEWFLO.
• Contents of parameter lists.
T050301.EPS
Item
Parameter
number
Name
R / W
(Read
and write)
Data range
Unit
Remarks
Disp.
U / D
Initial value
Parameter item number.
Parameter name.
Indicates parameter attributes.
R : Display only (writing is not permitted).
W : Writing is permitted.
Shows data setting ranges for numerical value
entry.
Shows data to be selected for data selection.
( ) in parentheses, data code is shown for the
display.
Engineering unit.
Remarks such as a description of the contents
are given.
D : Display can set parameter.
L : Parameter can be set by UP LOAD and
DOWN LOAD.
(Check all parameters after setting by DOWN
LOAD.)
Indicates the initial set values.
Description
5. PARAMETER SETUP

YOKOGAWA DY100 Specifications

General

Brand	YOKOGAWA
Model	DY100
Category	Measuring Instruments
Language	English