i
TI 32P01J10-01EN
Introduction
ProSafe-RS is a safety control system aimed at protecting people, environment, and equipment
from unexpected accidents or problems at a plant.
This manual describes the requirements for installation (control room size and power supply
requirements), storage and transportation, and wiring.
Chapter 1 System Installation Requirements
This chapter describes the engineering specications that cover the control room design/
environment, power supply system, grounding, noise prevention, corrosive-gas environment
compatibility and compliance with marine standards for the ProSafe-RS system.
Chapter 2 Transportation, Storage and Installation
This chapter describes precautions for the transport, unpacking and storage of the ProSafe-RS
system. This chapter also describes temperature and humidity changes when temporarily storing
the ProSafe-RS system, and how to install cabinets and rack mounted devices.
Chapter 3 Cabling
This chapter describes how to connect power, ground, signal and bus cables to the installed
devices, and how to connect optical ber cables.
Chapter 4 Installation Specications
This chapter covers the power consumption, power dissipation, in-rush current, and fuse and
breaker ratings as well as the parts that need replacement within 10 years. Read this section
when deciding the power supply capacity.
Chapter 5 Post-installation Inspection and Environmental Preservation
This chapter describes items that must be checked before turning on power and the precautions
to be taken to safeguard the environment after installing the system.
All Rights Reserved Copyright © 2015, Yokogawa Electric Corporation
Nov. 27, 2015-00
To Next Page
Loading...
Need help?
General
