1. System Installation Requirements
1-46
TI 32P01J10-01EN
Oct. 25, 2016-00
When Installing Unit Components with No Space between Them
When installing two unit components with no space between them, attach an EMI shielding
gasket onto the bottom surface of the lower bend of the upper unit. However, for the unit installed
at the bottom of the component mounting area, no EMI shielding gasket needs to be attached
onto its lower bend.
For the EMI shielding gaskets, use the model introduced in the paragraph under “When Leaving
a Large Space between Unit Components.”
EMI shielding gasket
(1)
(2)
(1)
(2)
EMI shielding gasket
Unnecessary where a dummy plate or unit component is not installed beneath (2).
EMI shielding gasket is unnecessary because it is
attached to the unit (1) above.
F010807.ai
Figure Examples of Installing EMI Shielding Gasket to Unit Component
When Installing Unit Components Unevenly Inside Cabinet
When installing unit components unevenly and gathering them to the upper or lower part of
a cabinet, leaving a large space in the cabinet, install dummy plates. Attach an EMI shielding
gasket to the dummy plates.
For the EMI shielding gaskets, use the model introduced in the paragraph under “When Leaving
a Large Space between Unit Components.”
SEE
ALSO
For how to attach EMI shielding gaskets, refer to “When Leaving a Large Space between Unit Components.”
Dummy plate
Dummy plate
Unit component
Dummy plate
Unit component
Dummy plate
Dummy plate
Dummy plate
Dummy plate
Dummy plate
Dummy plate
Dummy plate
Unit component
Unit component
Unit component
Unit component
EMI
shielding
gasket
EMI
shielding
gasket
EMI
shielding
gasket
Dummy plate
Dummy plate
Dummy plate
Dummy plate
Dummy plate
F010808.ai
Figure Example of Installing Dummy Plates and EMI Shielding Gaskets in Cabinet
To Next Page
Loading...
Need help?
General
