During installation, do not damage the insulation material on the surface of the indoor unit.
3. The Installation of the Indoor Unit
10
Installation and Maintenance
CAUTION
2. The Tools and Instruments for Installation
Number
1
2
3
4
5
6
7
Tool
Standard screwdriver
Vacuum pump
Charge hose
Tube bender
Adjustable wrench
Tube cutter
Cross head screw-driver
Number
8
9
10
11
12
13
14
Tool
Knife or wire stripper
Gradienter
Hammer
Churn drill
Tube expander
Inner hexagon spanner
Tape measure
3.1 Before installation
·When moving the unit during or after unpacking, make sure to lift it by holding its lifting lugs.
Do not exert any pressure on other parts, especially the refrigerant ing, drain piping and flange parts. tub
·Wear protective gears when install the unit.
·Install correctly according to the installation manual.
·Confirm the following points:
○ Unit type/Power supply specification
○ Pipes/Wires/Small parts
○ Accessory items
AUV-18HR4SSA1
AUV-24HR4SFA1
AUV-36HR6SDB1
AUV-48HR6SEC1
AUV-60HR6SPC1
RPFC-2.0UNZ1NH
RPFC-3.0UNZ1NH
RPFC-4.0UNZ1NH
RPFC-6.0UNZ1NH
RPFC-6.5UNZ1NH
YFGN18BZNRZUH1
YFGN24BZNRZUH1
YFGN36BZMRZUH1
YFGN48BZMRZUH1
YFGN55BZMRZUH1
RAS-2.0UNZGNH1
RAS-3.0UNZGNH1
RAS-4.0UNZGMH1
RAS-6.0UNZGMH1
RAS-6.5UNZGMH1
●
Blowing out the surviwal heating air
When stoping the air conditioner in normal operation, the fan motor would run with low speed for a while to blow
out the residual heating air.
To Next Page
Loading...
Need help?
General
