This air-conditioner shall be installed properly by qualified installation technicians in accordance with the
installation instructions provided with the unit.
The appliance shall also be installed in accordance with national wiring regulations.
Before installation, check if the voltage of the power supply is the same as the voltage at installation site
shown on the nameplate.
You must not carry on any transformation to this product, otherwise, it may possibly
cause such consequences as water leakage, breakdown, short-circuit, electric
shock, fire, etc..
The work such as tubing welding, etc. should be carried out far away from flammable
explosive material vessels, including the air-conditioner refrigerant, to guarantee the
security of the site.
To protect the air-conditioner from heavy corrosion, avoid installing the outdoor unit
where salty seawater can splash directly onto it or in sulphurous air near a spa. Do
not install the air-conditioner where excessively high heat-generating objects are
placed.
If the supply cord is damaged, it must be replaced by the factory or its service
department in case of danger.
The place where this product is installed must have the reliable electrical earth facility
and protections. Please do not connect the grounding of this product to various kinds of
air-feeding ducts, drain piping, lightning protection facility as well as other tubing lines to
avoid receiving an electric shock and damages caused by other factors.
Wiring must be done by a qualified electrician. All the wiring must comply with the local
electrical codes.
Consider the capacity of the electric current of your electrical meter and socket before
installation
The power wire where this product is installed is supposed to have the independent
leakage protective device and the electric current over-load protection device which are
provided for this product. If not, it will caus an eleectric shock or a fire.
The appliance is not to be used by persons who lack of experience and knowledge,
unless they have been given supervision or instruction. Children should be supervised
not to play with the appliance.
Means for disconnection, which can provide full disconnection in all poles, must be
incorporated in the fixed wiring in accordance with the wiring rules.
Caution Statements
2
DANGER
WARNING
The cord of the H07RN-F type or the electrically equivalent type must be used for
power connection and interconnection between outdoor unit and indoor unit. The size
of the cord is detailed in “Installation and Maintenance” part.
Details of type and rating of fuses, or rating of circuit breakers / ELB is detailed in
“Installation and Maintenance” part.
If the fuses in units burn up, please call the service agency to change it.
Please do not change it by yourself, or else may result in accident, for example shock.
The wiring diagram with a clear indication of the connections and wiring to external
control devices and supply cord is detailed in “Electrical Wiring Diagram” part.
The method of connection of the appliance to the electrical supply and interconnection
of separate components is detailed in “Installation and Maintenance” part.
It is necessary to allow disconnection of the appliance from the supply after installation.
The disconnection may be achieved by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cut-out, this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the utility.
AUV-18HR4SSA1
AUV-24HR4SFA1
AUV-36HR6SDB1
AUV-48HR6SEC1
AUV-60HR6SPC1
RPFC-2.0UNZ1NH
RPFC-3.0UNZ1NH
RPFC-4.0UNZ1NH
RPFC-6.0UNZ1NH
RPFC-6.5UNZ1NH
YFGN18BZNRZUH1
YFGN24BZNRZUH1
YFGN36BZMRZUH1
YFGN48BZMRZUH1
YFGN55BZMRZUH1
RAS-2.0UNZGNH1
RAS-3.0UNZGNH1
RAS-4.0UNZGMH1
RAS-6.0UNZGMH1
RAS-6.5UNZGMH1
●
Blowing out the surviwal heating air
When stoping the air conditioner in normal operation, the fan motor would run with low speed for a while to blow
out the residual heating air.
To Next Page
Loading...
Need help?
General
