28
English
Find more information at www.zaco.eu
Product maintenance
Use a dry cloth to clean the robot‘s loading pins and drop sensors to maintain their
sensitivity. Instructions for doing so are shown in the images below:
Drop sensor and charging pin maintenance
WARNING
• Please take out the battery when the device will not be used for a long time. If a battery
leak occurs, please remove the battery, clean the battery compartment, and contact the
ZACO Customer Service.
• If the battery is deeply discharged or not used for a long time, the battery capacity will
be reduced, and it is recommended to activate the battery. To activate it, manually place
the robot on the charging station. Remove the robot after charging for 3 minutes and
repeat this 3 times. After that, charge the device for 3-5 hours.
• This product uses a long-life battery that does not require frequent replacement.
If you want to replace it anyway, please contact the ZACO Customer Service.
Clean the nose wheel regularly to avoid
being tangled by hair.
Clean up sensors regularly to maintain
the sensitivity.
To Next Page
Loading...
Need help?
General
