Zapi DUALAC2 User Manual

Page 47
5.4.3 "Dualac2&hp" and "Dualac2&hp Power" - Master
See chapter 5.4.1.
5.4.4 "Dualac2&hp" and "Dualac2&hp Power" - Slave
Using the config menu of the programming console, the user can configure the follow-
ing functions.
SUBMENU "SET OPTIONS"
Not available.
SUBMENU "ADJUSTEMENT"
1 SET BATTERY TYPE: selects the nominal battery voltage;
2 ADJUST BATTERY: fine adjustment of the battery voltage measured by the control-
ler.
3 SET ACCELER MIN: This parameter is used to adjust minimum value of the lift
potentiometer. Press ENTER, pull the lever till the lift switch
closes, then record the value (OUT --> ENTER).
4 SET ACCELER MAX: This parameter is used to adjust maximum value of the lift
potentiometer. Press ENTER, pull the lever to the maximum,
then record the value (OUT --> ENTER).
5 THROTTLE 0 ZONE: establishes a deadband in the lifting accelerator input curve
(see also curve below).
6 THROTTLE X POINT: these parameter change the characteristic of the lifting accel-
erator input curve.
7 THROTTLE Y POINT: these parameter change the characteristic of the lifting accel-
erator input curve.
8 AUX OUPUT VOLTAGE: this parameter adjust the voltage of the auxiliary output
coil (hydraulic steering contactor coil), PWM output A31.

Zapi DUALAC2 Specifications

General

Brand	Zapi
Model	DUALAC2
Category	Inverter
Language	English