Zebra S4M Installation Instructions

© 2005 ZIH Corp. All product names and numbers are Zebra
trademarks, and Zebra and the Zebra logo are registered
trademarks of ZIH Corp. All rights reserved.
20002L-001 Rev. A
10/3/05
Printed on
chlorine-free
recycled paper.
S4M
Pulley and Gears Maintenance Kit
Installation Instructions
This kit includes the parts and documentation necessary to install the drive system
maintenance kit into the S4M™. Read these instructions thoroughly before attempting to
install this kit.
Prepare for Installation
Parts List
Before proceeding, verify that your kit contains the items for your printer listed below.
Caution • Turn Off (O) the printer and disconnect it from the power source before
performing the following procedure.
Table 1 • Kit Parts List
3 Item Qty Part Number Description
Ref
1
20002M
Gear and Pulley Maintenance Kit
1
1
20002
Compound Gear
2
1
77181
Intermediate Gear
3
1
77227
Compound Pulley
4
2
10856
Set Screw, M4 × 0.7
5
1
77225
Screw, M5 × 20
Bold = Part available for purchase.
Italic = Part not available for purchase, listed and shown for reference only.

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g