Zenner zelsius C5-IUF Installation And Operating Instructions

16
MID - Declaration of Conformity
zelsius®C5-IUFisproducedand
tested in compliance with the Euro-
pean Measuring Instruments Direc-
tive2014/32/EU(MID).Accordingto
this directive, devices are no longer
carryinganinitialvericationstamp,
but rather the year of the device’s
declarationofconformity(recogniz-
able on the front of the device, for ex-
ample:M19=2019).TheMIDcontrols
the use of measuring device up to the
moment they are placed on the mar-
ketresp.theirrstputtingintouse.
Aerthis,thenationalregulations
for devices subject to compulsory
vericationapplywithintheEU.The
durationofinitialvericationvalidity
inGermanyremains5yearsforheat
meters.Aerthisperiodhasexpired,
the measuring device may no longer
be used for billing in commercial use.
The regulations resp. validity period
may vary in other countries of the EU.
Ifyouhavequestions,pleasedirect
them to info@zenner.com
The declaration of conformity is
attached to each measuring instru-
ment. The latest information about
this product can be downloaded
from www.zenner.com
Safety instructions
Electro-magnetic interference
zelsius®C5-IUFfullsthenational
andinternationalrequirementsfor
interference resistance. To avoid
malfunctions due to other interfer-
ences,donotinstalluorescent
lamps, switch cabinets or electric
devices such as motors or pumps in
the immediate vicinity of the meter.
Cables leaving the meter should not
belaidparalleltolivecables(230V)
(minimumdistance0.2m).
Care instructions
Clean plastic surfaces with a damp
cloth only. Do not use any scouring
or aggressive cleaning agents! The
device is maintenance-free during
theservicelife.Repairsmayonlybe
carried out by the manufacturer or
authorized service partners.
Installation manual
Safety instructions for installation
Readtheseinstructionscarefully
right up to the end before starting to
mount the device! The installation
hastobedonebyqualiedprofes-
sional personnel. The current laws
and regulations have to be observed,
especially the PTB technical guide-
linesK8undK9,EN1434part1+6,(in
Germany also AGFW directive FW202,
FW510andFW218).Atdeviceswith
M-Bus the general rules of technol-
ogy and the respective regulations
for electrical installations have to be
followed. Caution with discharge
of hot water during the installation
– scalding danger! Do not carry the
meter by the cables.
The maximum heating water
temperatureattheowsensor
maynotexceed105ºCresp.130
°C. For heating systems with a lack
of temperature mixing resp. with
temperaturestraticationastraight
pipeline of min. 10 x DN has to be
provided upstream of the meter. The
owsensoriswear-free,thereare
no moving parts. No straight lengths
ofpiperequired.Itisimportantto
ensureadequatesystempressureto
avoid cavitation.
With heating water temperatures of
90 °C and more as well as combined
heat and cooling measuring or only
cooling measuring the calculator has
to be mounted on the wall for protec-
tionofexternalcondensation(for
Germany and Austria: in the case of
cooling and combined heat / cooling
meters, the cooling registers are not
calibrated and may not be used for
billing purposes in commercial trans-
actions. For this purpose, devices
with a separate type-examination
certicatearecurrentlyrequired).

Zenner zelsius C5-IUF Specifications

General

Brand	Zenner
Model	zelsius C5-IUF
Category	Measuring Instruments
Language	English