Zephyr Pisa ZPI-E30BG User Manual

17
Pisa Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
Mounting the Hood
6. 24” Models Only. From inside the hood,
secure (1) M4x8 screw into each lower
installation bracket. The position of this
screw is adjustable to accommodate
various cabinet bottom thicknesses.
7. 24” Models Only. Install (2) 3/16x40
screws into the captive nuts of each
upper installation bracket. Tighten
screws to adjust the height of the range
hood until there is no gap between the
cabinet and front edge of the hood.
8. 30” & 36” Models Only. Secure hood
body to cabinet base by (4) M4 x 16mm
screws through the bottom of range
hood.
A
9. Secure (2) 1” wood screws (A) into the
screw holes on the left and right sides of
the filter opening.

Zephyr Pisa ZPI-E30BG Specifications

General

Color	stainless steel
Hood Type	under cabinet
Venting Type	convertible
Temperature Sensor	no
Number of Fan Speeds	3
CFM	500 cubic feet per minute
Filters	2
Sones	5.3 sones
Control Type	slide
Delay Start	no
Interior Light	yes
Remote Control	no
Voltage	120 volts

Weight and Dimensions

Depth	11 1/8 inches
Height	11 1/4 inches
Width	29 7/8 inches
Net Weight	33 pounds