Zephyr Pisa ZPI-E30BG User Manual

18
Pisa Use, Care, and Installation Guide
PISA
UNDERCABINET
CORE
Installation Instructions
Mounting the Hood
10. Place 6” round ducting over blower
collar and secure with aluminum
duct tape. If using hood in ductless
recirculating mode, refer to the Ductless
Recirculation section. Install electrical
wiring. Make sure no packing material
is inside hood. Power up hood check
for leaks around duct tape and verify all
functions.
11. Measure distance between back of
range hood and wall (if any) and cut
filler panel to the appropriate depth
using a utility knife or heavy-duty
scissors.
12. Install filler panel to bottom of hood by
(4) 3.5x10 screws for 24” model or (5)
3.5x10 screws for 30” and 36” model.

Zephyr Pisa ZPI-E30BG Specifications

General

Color	stainless steel
Hood Type	under cabinet
Venting Type	convertible
Temperature Sensor	no
Number of Fan Speeds	3
CFM	500 cubic feet per minute
Filters	2
Sones	5.3 sones
Control Type	slide
Delay Start	no
Interior Light	yes
Remote Control	no
Voltage	120 volts

Weight and Dimensions

Depth	11 1/8 inches
Height	11 1/4 inches
Width	29 7/8 inches
Net Weight	33 pounds