21
11.0 PRE-FLIGHT CHECKLIST
• Drone, controller and your device are all fully charged.
• All blades are installed correctly.
• All arms are fully unfolded.
• Camera lens is clean, free of dirt and dust.
• All parts used are genuine Zero-X Pro Evolved 4K products. Using other
parts that are not made specifically for the Evolved 4K drone may cause
safety issues or cause the drone to malfunction.
• The Zero-X Pro Evolved 4K App is downloaded and installed on your
device.
12.0 FLIGHT SAFETY
Before flying your drone make sure that you are in a safe surrounding.
CASA restrictions regarding flying drones require the drone to be no closer
than 5.5 kms from any airport or airfield while flying. Drones should also not
be flown higher than 120 metres above the ground, over populated areas or
any closer than 30 metres from vehicles, people or animals.
It is also required that you check your surroundings before taking off,
making sure there are no obstacles or dangers in the area including
overhead power lines and bodies of water. If there are hazards present in
your intended area of flight, please consider an alternative location. Tall
structures and large metal structures may affect the accuracy of the inbuilt
GPS and compass.
Be sure to fly your drone in appropriate weather conditions, it is advised to
refrain from flying during very high temperatures, snow, extremely strong
winds, rain or fog. Please also note this drone's GPS system is unable to be
used in polar regions.
For safety, Default control of the drone is set to Beginner where the flight
parameters are fixed. To change the parameters, Please deselect the
Beginner mode in the App's Flight Settings. To download the App please
refer to page 20
13.0 FLYING YOUR EVOLVED 4K DRONE
Please read through all of the instructions below before attempting to start
the launch the Evolved 4K drone.
13.1 PAIRING YOUR DRONE AND REMOTE CONTROL
1. Hold down the button and swipe the Power ON button to the right to
turn on the remote control.
2. Ensure that the battery is connected correctly to the drone. Power ON
your drone by pressing down the button on the top of the battery for 3
seconds. The drone will make a sound and the 4 lights will come on in a
sequence. The front lights will flash red and the rear lights flash green.
The drone will then beep two times and the lights will switch to flashing
alternatively yellow, green and red front and rear.
To Next Page
Loading...
Need help?
General
