Zetor Proxima 90 User Manual

169
MAINTENANCE INSTRUCTIONS
E733 G731 G735a
LUBRICATION AND FILLING POINTS
OF THE FRONT DRIVING AXLE
1 - Steering knuckle lubricator.
2 - Sliding bearing (2x) of the front driv-
ing axle.
3 - Gearbox oil drain hole.
4 - Oil filling and inspection hole on the
gearbox (after screwing off the in-
spection screw the oil level shall
reach the lower edge of the inspec-
tion hole).
OIL FILLING, INSPECTION AND
DRAIN HOLES OF FRONT WHEEL
REDUCERS
Carry out check, filling and draining of oil
through one hole after turning the re-
ducer as illustrated.
1. Check of oil level – the hole is in the
reducer horizontal axis (after screw-
ing off the inspection screw the oil
level shall reach the lower edge of
the inspection hole).
2. Filling of oil – the hole is on the top.
3. Drainage of oil from a non-braked
axle – the hole is in the bottom.
4. Drainage of oil from a braked axle –
the hole is in the bottom.
REFILLING OF BRAKE FLUID
The tank is located on the left side of the
tractor in front of the cabin and accessi-
ble after lifting of the bonnet.
Keep level of brake fluid within 3/4 (max.
height) and 1/2 (min. level) of the tank
volume.
When manipulating with brake
fluid observe strict cleanness.
Check level every day before you
drive out.

Zetor Proxima 90 Specifications

General

Brand	Zetor
Model	Proxima 90
Category	Tractor
Language	English