Zetor UTILIX HT 45 User Manual

Changing coolant
Caution: Do not remove the radiator cap while the engine is hot.
A
llow the en
g
ine cool down and then turn the cap slowl
y
to make sure that there is no excessive
p
ressure in the radiator
.
Caution:
Serious burns, can result from the contents of pressurized, hot radiators.
A
llow the en
g
ine to cool down completel
y
before openin
g
radiator cap
.
Anti freeze
If the coolant freezes, it may damage the engine.
Flush the radiator before replacing the antifreeze.
Prepare the antifreeze solution according to the specific antifreeze instructions and local climatic conditions.
Replace the solution in the radiator.
In case of loss of solution due to evaporation or overflow, add more solution of the original composition.
1 - Radiator Ca
p
1. Open the drain valve in front of the engine oil filter and
drain the coolant.
U18N084
1 - Drain Valve
2. Simultaneously open the radiator cap.
3. To clean the cooling system thoroughly, flush it with
a gentle stream of water.
4. Close the drain valve and fill the cooling system with
new coolant.
5. Start the engine and let it idle for about 5 minutes, then
check the fluid level again and add more coolant if
necessary.
U18N085
MAINTENANCE INSTRUCTIONS
103

Zetor UTILIX HT 45 Specifications

General

Brand	Zetor
Model	UTILIX HT 45
Category	Tractor
Language	English