10
Installation and Balance Adjustment
To facilitate the adjustment procedure, we recommend locking the three axes
before the adjustment and unlock and adjust them one by one.
1. Unlock the tilt axis and Quick Release Plate Latch, push the camera to move
forward or backward until the camera can stay still and almost level with its lens
facing front (as shown below). Complete this step by tightening up Quick Release
Plate Latch.
2. Make the lens face up, slightly loosen the thumb screw of the tilt axis, and push the
camera to move upward or downward until the camera can stay still with the lens facing
up. Complete this step by tightening up the thumb screw.
Balance Adjustment
To Next Page
Loading...
Need help?
General
