18
How to Use
Extension Arm Installation and Detachment
1. Remove 4 M3 screws on horizontal arm of stabilizer with M2.5 wrench.
2. Remove wire cover set screws with M1.3 wrench.
3. Pull out the tilt axis motor and wire cover (Be careful not to break or damage the wires
inside).
4. Remove the rubber cover on the extension arm and install the extension arm on the
horizontal arm.
5. Install the M3 screws provided and removed in Step 1 to the horizontal arm.
6. Make sure all the wires are inside the horizontal arm and then install the wire cover to
the horizontal arm. Tighten the set screws and install the rubber cover to the horizontal
arm.
1 2
3 4
5 6
To Next Page
Loading...
Need help?
General
