Zline DW-WM-18 User Manual

10
Step 3: Check Water Supply Requirements and Cautions
The hot water supply line pressure must be between 0.04-1MPa.
Adjust the water heater to deliver water between 120°F ~149°F.
The dishwasher must be connected to a hot water supply between
120°F~149 °F. This temperature range provides the best
washing result and shortest cycle time. Temperature should not
exceed 149°F to prevent damage to dishes.
Ensure that the water supply valve is turned off before connecting the hot
water supply line to the dishwasher.
Seal the hot water supply line connections using teflon tape or sealing
compound to stop any water leakage.
When you install the dishwasher, ensure there is nothing on the drain hose
and be careful not to tear it during the installation process.
Figure 2
installing the dishwasher

Zline DW-WM-18 Specifications

General

Style	built-in dishwashers
Color	white matte, matte white
Load Capacity	16
Number of Cycles	6
Options/Settings	energy save, quick wash, normal, rinse, eco wash, heavy wash, sanitary, high temperature wash, glass, heat dry option
Drying Type	heated drying
Noise level	40 decibels adjusted
Control Type	touchpad
Delay Start	yes
Number of Racks	2
Sanitize Settings	no
Annual Energy Consumption	234 kilowatt hours
Voltage	120 volts

Weight and Dimensions

Depth	23 inches
Height	32 1/2 inches
Width	17 3/4 inches
Net Weight	73.7 pounds