31
How Your Dishwasher Cleans
Your dishwasher cleans by spraying a mixture of hot water and detergent through the
spray arms against soiled surfaces.
The dishwasher fills with water covering the filter area. Water is then pumped through
the multiple filter and spray arms. Separated soil particles go down the drain as the
water is pumped out and replaced with clean water.
The number of water fills will vary with the cycle being used.
Wash Cycle Selections
Cycle times are approximate and will vary with the options selected. Hot water is
necessary to activate the detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature. If it is not at the appropriate temperature
the timer will delay the cycle to allow automatic water heating during the main wash.
When the HI-TEMP wash is selected an even higher temperature will be assured to
handle heavier soil loads.
Getting Started
1. Load the dishwasher (see dish preparation and loading sections).
2. Add detergent (see filling the detergent dispenser).
3. Add rinse aid (see filling the rinse aid dispenser).
4. Select desired CYCLE (see cycle chart).
5. Select desired OPTIONS (see control panel). The indicator light above the pad will
glow when selected.
6. To start, press start/cancel (see control panel). Then close door
Features of your New Dishwasher
Note:
Your dishwasher has the controls mounted on the front of the door. The door
should be closed first if you want to operate the machine.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
