Chapter 3
Configuration Prepara-
tion
Table of Contents
Configure the IP Address of the Computer.................................................................... 12
Login................................................................................................................................ 13
This manual uses the Windows operating system as an example for describing how to
configure the H3140. Before configuring the H3140, you need to perform the following
operations:
Ensure that a crossover or straight-through Ethernet cable connects a computer to
the device.
Ensure that the TCP/IP configuration on the computer is correct.
Stop any firewall or other security software operating on the computer.
Disable the proxy setting of Internet Explorer.
3.1 Configure the IP Address of the Computer
Abstract
To log in to the H3140 on a computer, you need to set the IP address of the computer
to ensure that the IP address of the computer and the maintenance IP address of the
H3140 are in the same network segment.
Context
The default maintenance IP address of the H3140 is as follows:
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
Steps
1. Use an Ethernet cable to connect a local computer to the LAN interface of the
H3140.
12 SJ-20210621164956-009 | 2021-12-07(R1.0)
To Next Page
Loading...
Need help?
General
