Confidential and Proprietary Information of ZTE CORPORATION 19
• Automatic: Device searches for available network.
• WCDMA Only: Device searches for WCDMA network only.
• GSM Only: Device searches for GSM network only.
Click Apply to confirm your configuration.
APN Setting
Select Settings > 3G Settings > APN Setting, the APN parameters are shown in the following figure:
• Profile Selection: Choose the desired profile name.
• APN: Access Point Name.
• PDP Setting: PDP address mode. If a fixed IP address is given by your service provider, select Manual
PDP. Otherwise select the Auto PDP and the router will automatically obtain this parameter.
• DNS: If a fixed IP address is given by your service provider, then choose Manual DNS. Otherwise,
choose Auto DNS, and device will automatically obtain parameters.
• Authentication: Password Authentication Protocol (PAP) provides a simple method without encryption
for the peer to establish its identity using a 2-way handshake. Challenge-Handshake Authentication
Protocol (CHAP) is used to periodically verify the identity of the peer using a 3-way handshake.
• User Name: User name is used to obtain authentication from the ISP when the connection is established
• Password: Password is used to obtain authentication from the ISP when the connection is established.
Click Set default to set this profile as the default profile.
Wi-Fi Settings
Station list
To Next Page
Loading...
Need help?
General
