Additional Functions
OBD UPDATER / TROUBLESHOOTING
29
Setting the Unit of Measurement
1. Use the DOWN
button, as neces-
sary, to highlight Unit of Measurement
in the Main Menu, then press the
ENTER
button.
2. Use the DOWN
button, as neces-
sary, to highlight the desired
unit of
measurement.
3. When the des
ired unit of measurement
value is selected, press the ENTER
button to save y
our changes and
return to
t
he Main Menu.
Exiting the MENU Mode
Press and hold the ENTER button to exit the Menu mode.
OBD UPDATER
Use these procedures to verify your tool’s firmware is current, and to
perform firmware updates when available.
1. Visit www ZurichDiagnostics.com, downlo
ad and install the latest
version of OBD Updater.
2. Conn
ect your tool to your PC using a Mini USB cable and run the
OBD Updater so
ftware.
3. Follo
w the on-screen prompts to install the firmware upd
ate.
If no update is
available, the software displays the message
“No updates available.”
TROUBLESHOOTING
Q: Why can I not erase some codes?
A: Unlike other codes which can be removed from the vehicle’s
control module, PERMANENT codes cannot. This holds true
regardless of the tool being used or color of the status LED display.
PERMANENT codes will automatically erase when the control
module no longer detects the fault that originally caused the code.
To Next Page
Loading...
Need help?
General
