EasyManuals Logo
Home>A.O. Smith>Water Heater>ProLine XE

A.O. Smith ProLine XE User Manual

A.O. Smith ProLine XE
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
MAINTENANCE
30 Residenal Hybrid Electric Heat Pump Water Heater Use and Care Guide
At least every five years, have a
qualified person inspect the T&P
Relief Valve and discharge pipe.
Damage caused by corrosive water
conditions, mineral deposits, or
other problems can only be deter-
mined when a qualified person
removes and inspects the valve and
its components.
Note that a dripping T&P Relief
Valve is usually caused by the
home’s water pressure being
too high or the lack of a Thermal
Expansion Tank. If your T&P Relief
Valve drips refer to “Drips from T&P
Relief Valve Discharge Pipe” section
on page 23.
Air Filter Maintenance
The heater will monitor the heat pump
operaon status and indicate whether
the lter should be cleaned. If the
User Interface Module displays “SF”
code, this indicates the lter should be
cleaned or replaced with the following
process (See exploded view of unit on
page 31 for air lter locaon).
 Before aempng to clean or
replace the air lter, turn o power to
the water heater at the circuit breaker/
fuse box.
1
Take the two tabs on the air
lter and remove (slide) it
from the top cover of the unit.
2
If you are replacing the lter,
skip to step four. To clean the
lter, use a vacuum with a
hose aachment to remove any dust
or debris.
3
Place the new or cleaned lter
into the water heater.
4
Restore power to the water
heater and turn the water
heater on.
NOTE: The water heater may conduct a
system diagnosc prior to operaon.

Maintenance
 Before aempng to clean the
condensate drain pan or lines shut
o power to the water heater at the
circuit breaker/fuse box.
1
Remove the top shroud by
loosening the screws securing
it to the unit.
2
Check the condensate drain
pan and drain lines for any dirt
or debris that might interfere
with proper drainage. Wipe out any
dirt or debris with a damp cloth.
3
Once the condensate drain
pan and lines have been
inspected/cleaned, secure the
shroud back to the top of the water
heater.
4
Restore power to the water
heater and turn the water
heater on.
NOTE: The water heater will conduct a
system diagnosc prior to operaon.
MAINTENANCE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the A.O. Smith ProLine XE and is the answer not in the manual?

A.O. Smith ProLine XE Specifications

General IconGeneral
BrandA.O. Smith
ModelProLine XE
CategoryWater Heater
LanguageEnglish

Related product manuals