21Dialog 4422 IP Office
Start the Phone – Log On/Off
LAN access control (network authentication)
(Dialog 4422 v. 2 phone only).
Your telephone might require a network authentication to gain
access to the network. In this case you must enter a valid user
identity and PIN or password.
Note: The user identity and password used for the network
authentication is not the same user identity and password
you use to log on. The password is obtained from, and can
only be changed by the system administrator.
z Enter your user identity.
(The Minus key is used to remove a wrong entry.)
Press.
z Enter your PIN or password.
(The Minus key is used to remove a wrong entry.)
Note:
The password can be entered with letters or numbers, see
section “Entering letters and numbers” on page 27.
The PIN is the same as the Individual Authorization Code.
Only digits can be used as PIN. The PIN must be four digits
or more.
Press.
If your user identity and password are accepted, the phone
continues with the startup procedure.
Note: If your user identity and password are not accepted,
contact your system administrator.
LAN access control
Enter user ID:
To Next Page
Loading...
Need help?
General