ABB 6136/30M-101 User Manual

ENG
39
7.2.2 Calling up and saving light scenes
● Press "Light" button on remote control unit.
– The word "LIGHT" appears in the remote control unit display. This mode is active for 25
seconds. After this, the display goes back to audio/video. Press the LIGHT key one more
time if required.
● Switch the light scenes according to the table below.
„LIGHT+A“ in the table means that these two keys must be pressed one after the other (not
simultaneously).
Function Keys to be pressed
Call up light scene 1 LIGHT+A
Call up light scene 2 LIGHT+C
Call up light scene 3 LIGHT+D
Call up light scene 4 LIGHT+F
Save light scene 1 LIGHT+ LIST*+GO+A
Save light scene 2 LIGHT+ LIST*+GO +C
Save light scene 3 LIGHT+ LIST*+GO +D
Save light scene 4 LIGHT+ LIST*+GO +F
* The key LIST must be
pressed until STORE
appears in the display.
7.2.3 Switching off the consumers
When pressing the "STOP" button, all consumers can be switched off with one single button.

ABB 6136/30M-101 Specifications

General

Brand	ABB
Model	6136/30M-101
Category	Control Panel
Language	English