ABB ACH580-01 - Cover and Hood Installation; Drive Cover Reinstallation Procedures; Protective Hood Installation

ACH580 Installation, Operation and Maintenance Manual 45
ACH580-01 Installation
6. Re-install cover(s)
Frames R1...R4
1. Reinstall the cover: Put the tabs on the cover
top in their counterparts on the housing (1a)
and then press the cover (1b)
2. Tighten the retaining screw at the bottom with
a screwdriver.
Frame R5 cover installations
1. Slide the conduit box upwards (1a)
and tighten the retaining screws
(1b).
2. Install the cover, press it at the
bottom (2a) and tighten the
retaining screws (2b).
7. Install hood, if applicable
IP 55/UL (NEMA) Type 12, Frame R1...R9
Install the hood by following the instructions provided with the hood kit.
1b
2
1a
1
2
1a
1b
1b
2a
2b
Hood
ACH580_Inst_Op_Maint_Rev G.book Page 45