ABB ACS 607 User Manual

Appendix A – ACS/ACC/ACP 604/607 Technical Data
ACS/ACC/ACP 604/607 Drives ACx=ACS/ACC/ACP A-25
Protection Features Application program dependent features of the ACx 600 are listed
below. available as standard, optional
Preprogrammed Warnings: ACS 600 temperature, Motor
Identification Run, Drive Identification Number change, User Macro,
Target position (ACP), Positioning speed (ACP).
Programmable Automatic Reset Functions (ACS 600 Standard
Application Program only): after overcurrent, overvoltage,
undervoltage and analog input below minimum value
Information Functions: ACx 600 control software version, ACx 600
application software version, ACx 600 test date.
Preprogrammed
Faults
Standard
PFC, M/F
CraneDrive
MotionControl
System
Programmable
Fault Functions
Standard
PFC, M/F
CraneDrive
MotionControl
System
Program.
Supervision
Functions
Standard
PFC, M/F
CraneDrive
MotionControl
System
ACx 600 temperature Analog input below
minimum value
Speed 2 2
Overcurrent Loss of Control Panel Motor current
Short circuit External fault Motor torque 2 2
DC overvoltage Motor
overtemperature
Motor speed
Supply phase Thermistor/Pt 100 Reference 1
DC undervoltage Motor stalled Reference 2
Overfrequency Motor underload Actual value 1
Overspeed Loss of motor phase Speed
threshold
Internal fault Ground fault Torque
threshold
Internal fault on the
I/O control board
Speed measurement Position error
Ambient temperature Motor overspeed Position
threshold
User Macro Torque Joystick
Braking chopper (in
fieldbus mode)
Torque proving Brake long
falling time
Inverter overload Brake
No motor data Communication test
ID Run fail Following error
Position limits
Maximum speed
alteration
Speed difference
Communication error
Encoder interface
module

ABB ACS 607 Specifications

General

Brand	ABB
Model	ACS 607
Category	Controller
Language	English