ABB ACS255 User Manual

30
6.4. Advanced Keypad Operation ShortCuts
Function
When Display shows...
Press...
Result
Example
Select lowest Parameter
within Group
i.e. 

+
The first parameter of the
group is selected
Display shows 
Press
Display shows 
Set Parameter to
minimum value
Any numerical value
(Whilst editing a
parameter value)
+
The parameter is set to
the minimum value
When editing 
Display shows 
Press
Display shows
Adjusting individual digits
within a parameter value
Any numerical value
(Whilst editing a
parameter value)
+
Individual parameter
digits can be adjusted
When editing 
Display shows
Press
Display shows.
Press
Display shows.
Press
Display shows.
Press
Display shows.
6.5. Drive Operating Displays
Display
Status

Drive mains power applied, but no Enable or Run signal applied

Motor Autotune in progress.
x.x
Drive running, display shows output frequency (Hz)
Whilst the drive is running, the following displays
can be selected by briefly pressing the
button on the drive. Each press of the button will
cycle the display through to the next selection.
x.x
Drive running, display shows motor current (Amps)
x.x
Drive Running, display shows motor power (kW)
x.x
Drive Running, display shows customer selected units, see parameters
3400 DISPLAY SCALING FACTOR and 3405 DISPLAY SCALING SOURCE

Drive mains power not present, external 24 Volt control power supply present only

Output power hardware inhibited, hardware enable circuit open. External links are required to the STO inputs (terminals 12
and 13) as shown on page 23.

Parameters reset to factory default settings
For drive fault code displays, refer to section 13.1 on page 62

ABB ACS255 Specifications

General

Brand	ABB
Model	ACS255
Category	Controller
Language	English