ABB ACS320 series User Manual

Actual signals and parameters in the short view 33
6. Actual signals and
parameters in the short view
Note: When the control panel is in the short parameter view, that is when parameter
1611 PARAMETER VIEW is set to 2 (SHORT VIEW), the control panel only shows a
subset of all signals and parameters. These signals and parameters are described in
this chapter.
To be able to view all actual signals and parameters, set parameter 1611
PARAMETER VIEW to 3 (LONG VIEW). For the description of all actual signals and
parameters, refer to chapter Actual signals and parameters in ACS320 user’s manual
(3AUA0000062599 [English]).
Terms and abbreviations
Fieldbus equivalent
Example: If parameter 2008 MAXIMUM FREQ (see page 40) is set from an external
control system, an integer value of 1 corresponds to 0.1 Hz. All the read and sent
values are limited to 16 bits (-32768…32767).
Term Definition
Actual signal Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01…04 contain actual signals.
Def Parameter default value
E Refers to types 03E- with European parametrization
FbEq Fieldbus equivalent: The scaling between the value and the integer used in
serial communication.
Parameter A user-adjustable operation instruction of the drive. Groups 10…99 contain
parameters.
Note: Parameter selections are shown on the Basic control panel as integer
values. Eg parameter 1001 EXT1 COMMANDS selection COMM is shown as
value 10 (which is equal to the fieldbus equivalent FbEq).
U Refers to types 03U- with US parametrization

ABB ACS320 series Specifications

General

Brand	ABB
Model	ACS320 series
Category	Controller
Language	English