74 AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B
Identification plate
Identification plates
The gas analyzer has several identification plates:
• The gas analyzer identification plate is located outside on a side wall of
the system housing.
• The system housing identification plate is located on the right side wall
inside the 19-inch housing and on the left side wall inside the wall-mount
housing..
• The analyzer module identification plate is located externally on the
connection board (except for analyzer modules with direct connection to
the sample chamber).
• The electronics module identification plate is located externally on the
connection board.
• The pneumatic module identification plate is located at the rear behind
the back plate (behind the flow sensors).
Contents of the identification plate
The gas analyzer identification plate contains the following information:
• Part number (P-No.)
• Production number (F-No.)
• Order number (A-No.)
• Power supply (voltage, frequency, max. power consumption)
• Installed analyzers with sample components and measuring ranges
To Next Page
Loading...
Need help?
General
