Aztec 600 aluminium, ammonia, color, iron, manganese, phosphate
Single- and multi-stream colorimetric analyzers 1 Safety
IM/AZT6CR–EN Rev. J 3
1 Safety
Information in this manual is intended only to assist our customers in the efficient operation of our equipment. Use of this manual for
any other purpose is specifically prohibited and its contents are not to be reproduced in full or part without prior approval of the
Technical Publications Department.
1.1 Health & Safety
1.2 Electrical Safety – CEI/IEC 61010-1:2001-2
This equipment complies with the requirements of CEI/IEC 61010-1:2001-2 'Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the equipment may be impaired.
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
The relevant sections of these instructions must be read carefully before proceeding.
Warning labels on containers and packages must be observed.
Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel and in accordance
with the information given.
Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of
high pressure and/or temperature.
Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry. Normal safe
handling procedures must be used.
When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant Material Safety Data Sheets (where
applicable) may be obtained from the Company, together with servicing and spares information.
To Next Page
Loading...
Need help?
General
