ABB C1900 Series User Manual

17
tOtALS
PAGE
8765
4321
rESEt
t1 NO
t1 YES
COUNt
StOP
GO
StOP
t1 NO
YES
87654321
NO
5 CONTROL OPERATION…
Page Header –Totals Page.
Front Panel (Batch) Flow Total 1 (2)
The batch flow total is calculated from process variable 1 (2).
The flow total can be reset in the next frame if Reset Enable in Set Up Totals Page is set
to '
ENbL–Y'.
Counter Reset
The Front (Batch) Flow Total can be reset to the
Preset Value in Set Up Totals Page if
required.
Select '
t1 YES' to reset the counter ('t1' indicates Flow Total 1).
Note. If the Counter Reset is disabled in
Set Up Totals Page, the counter reset frame
is omitted.
Counter Stop/Go
Select '
GO' to start the counter or 'StOP' to stop it.
Note. If the Counter Stop/Go is disabled in
Set Up Totals Page, the frame can be
viewed but not altered. If a digital signal is assigned to
Totalizer Stop/Go, an active
digital signal sets the counter to
GO and the Counter cannot be stopped from the
front panel.
5.4 Totals Page Displays
This page is omitted from both faceplates if the Totalizer Option is not fitted. The page is also omitted from faceplate 1 if Total 1 is set
to
OFF and from faceplate 2 if Total 2 is set to OFF – refer to the Set Up Totals Page in the Advanced Software Options Manual.

ABB C1900 Series Specifications

General

Brand	ABB
Model	C1900 Series
Category	Measuring Instruments
Language	English