Operation Manual / TPL67-C.. - TPL71-C..
Hazards during operation and
maintenance
Page 25
© Copyright 2016 ABB. All rights reserved.
April 2016 HZTL2488_EN Revision C
Hazards during operation and maintenance
2.7
Mechanical hazards during operation
During normal operation, no mechanical hazards emanate from the turbo-
charger if it has been installed properly.
Contact with rotating parts can lead to serious injuries. The turbo-
charger must never be operated without a filter silencer or an air suction
branch. When the engine is at a standstill, the rotor can turn on its own
because of stack draught.
Operate the turbocharger in accordance with instructions.
During maintenance work, secure the rotor against unintentional ro-
tation.
Mechanical hazards when working on the turbocharger
During maintenance work, various risks can occur through the improper
handling of components, through the non-observance of work instructions,
due to inadequate care or as a consequence of insufficient training.
Severe injuries to personnel or fatal accidents can be caused by me-
chanical influences as a consequence of hazardous and inadequate
operational procedures.
Observe the general rules for occupational safety and prevention of
accidents.
Ensure workplace safety.
Only perform operations that are described in this document.
Only perform operations for which you have previously received in-
struction or training.
To Next Page
Loading...
Need help?
General
