EasyManuals Logo
Home>ABB>Industrial Equipment>TPL67-C Series

ABB TPL67-C Series User Manual

ABB TPL67-C Series
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Operation Manual / TPL67-C.. - TPL71-C..
Removal and installation
7
Installing the turbocharger
7.3
Page 88
© Copyright 2017 ABB. All rights reserved.
February 2017 HZTL2488_EN Revision D
Installing the turbocharger
7.3
Remove the cover from the oil connection.
Inspect the lifting gear.
Fasten a separate lifting gear to each of the two ribs on the bearing
casing provided for this purpose.
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be en-
sured that the orifice plates that are specified for the turbocharger have
been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
Fit the turbocharger to the engine.
Tighten the fixing screws at the foot in accordance with the engine
builder's instructions.
Fasten the gas, air and oil lines in accordance with the engine build-
er’s instructions.
Version with compressor wheel cooling system
Fit the air supply line (also see the chapter entitled Preliminary re-
marks / Layout and functioning).
Refit the parts of insulation which had been removed.
Plug in the cable connector on the speed sensor.
7.3

Table of Contents

Other manuals for ABB TPL67-C Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB TPL67-C Series and is the answer not in the manual?

ABB TPL67-C Series Specifications

General IconGeneral
BrandABB
ModelTPL67-C Series
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals