ABB TPS F Series User Manual

Operation Manual / TPS44-F.. - TPS61-F..
Mothballing the turbocharger
10
Taking the engine out of operation for
up to 12 months
10.1
Page 118
April 2015 HZTL2412_EN Revision E
If the total acid number (TAN) is greater than 2 mg KOH/g, the following
mothballing measures are necessary after taking an engine out of
operation:
 Dismantle the turbocharger.
 The rotor and the bearing parts must be removed by an official ABB
Turbocharging service station and refitted afterwards.
 Clean all parts.
 Machined, bright surfaces of steel and cast parts must be oiled with
anticorrosive oil.
 Reassemble complete turbocharger.
Rotor turning in stack draught
If the rotor turns as a result of the stack draught:
 Install blind flange between compressor casing outlet flange and
charge air duct.
© Copyright 2015 ABB. All rights reserved.

ABB TPS F Series Specifications

General

Brand	ABB
Model	TPS F Series
Category	Industrial Equipment
Language	English